Well since I no longer have to drive this thing on the streets I decided to go ahead and ruin the interior. By completely stripping it. It was far from clean in the first place so its all good. I had already dry iced the sound deadening a few weeks ago but had a few spots that didnt fully come off and the whole wheel well on each side.So today I decided to finish it up since its been so nice out lately.
Here is the before:
Plus this. Which Karl Wasabi kindly lent to me.
Plus this
Makes for ugly looking success.
So it is very rough looking still but I will eventually go over everything with a wire wheel to get all the residue off.
Next comes the cage for my ka24de powered drift car.
9 Comments
dope dope dope.
Hi!
Nice S13. I’m busy with stripping mine as well, but I’m not doing it as seriously as you are, since mine is my daily road car.
However, I had an idea of doing something with the wire loom. I thought it might be a good idea for your S13 too. I stripped my loom of all unnecessary and obsolete wires. I also shortend a lot of wires and hid a lot of the loom inside the body of the car, so the most of it isn’t visible anymore.
Take a look of what I did on my blog if you like. johnjoosten.net
Should have used dry ice.
=D
I was half expecting to see a shirtless you with a title like “strippin”
That would have been awkward aha. I did use dry ice on all of the floor. The wheel wells were too thin to use dry ice and would just pound in with the deadening. So heat and scraping was needed. And the wires that run through the back. I plan on routing them through the inside of the body as you said, Skippy. Makes it look much cleaner in there.
sweeett.. after the cage it must be a sr
I regret making my car non streetable
Dope! I need to finish strippin mine. Nice work man..stoked to see the cage in there
I <3 stripped interiors.
Rock on mang.